meta data for this page
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| equipment:edwards-e306a:log [2026/04/05 00:39] – [Day 2026-04-04 (q3k, Hugo, Rob)] q3k | equipment:edwards-e306a:log [2026/04/11 22:36] (current) – q3k | ||
|---|---|---|---|
| Line 57: | Line 57: | ||
| 3D printed a holder for the new vent valve, but needs some small rework to hold the valve better. | 3D printed a holder for the new vent valve, but needs some small rework to hold the valve better. | ||
| + | |||
| + | ==== Day 2026-04-12 (q3k) ==== | ||
| + | |||
| + | Fit new vent valve holder. Still a bit loose but better. Should probably hold the pipeline instead of the valve... | ||
| + | |||
| + | Reprinted knob to fit shaft better. Partially retapped shaft to M6 - previous thread didn't seem metric. | ||
| + | |||
| + | Fixed leak at pirani gauge after swapping it for some tests earlier. Took normal KF centering ring. | ||
| + | |||
| + | Attempted to run diffusion pump. A bunch of stuff offgassed and the pump sizzled but there was no extra vacuum. Need to inspect and probably fill, no other choice now... | ||