meta data for this page
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| projects:micromanipulator:start [2026/10/03 23:46] – [2026-10-03 (rahix)] rahix | projects:micromanipulator:start [2026/10/03 23:57] (current) – [2026-10-03 (rahix)] rahix | ||
|---|---|---|---|
| Line 23: | Line 23: | ||
| < | < | ||
| + | M56 J0 (calibrating X) (ideally watch the curves to see if it looks mostly linear) | ||
| + | M56 J1 (calibrating Y) | ||
| + | M56 J2 (calibrating Z) | ||
| + | G28 (homing all axes) | ||
| + | G0 X0 | ||
| + | G0 Y0 | ||
| + | G0 Z0 | ||
| </ | </ | ||
| + | |||
| + | If any of the axes don't move to the 0 position (center) with the relevant G0 command, you may have to try again. If all else fails, power-cycle the microcontroller... | ||
| ==== 2026-09-27 (anuejn, rahix) ==== | ==== 2026-09-27 (anuejn, rahix) ==== | ||
| Now pivoting to using the micro-manipulator for a laser fiber alignment. See [[..: | Now pivoting to using the micro-manipulator for a laser fiber alignment. See [[..: | ||